Surf eels

[surfstix1963]

must have been a PITA to drill the thru wire on something that thin.

[madcaster]

must have been a PITA to drill the thru wire on something that thin.

The dowel is sawed in half, and then ran thru the table saw and glues back together. Creating a square whole down the center

[surfstix1963]

2 pcs. got ya

[speedy]

[FONT=Calibri][SIZE=3]The dowel is sawed in half, and then ran thru the table saw and glues back together.

what glue did u use ? and is it fully sealed end to end .

[madcaster]

Elmer’s water proof glue. The glue will seal the grove. I place a larger wire in the grove before glue up. This allows you to twist it a few time while the glue is drying .This will allow you to pull the wire out, leaving a tube used to wire up the plug
Before glue up, the rear of the plug can be hollowed out to create a chamber for lead to be poured in later.