Results 1 to 3 of 3

Thread: My own one bearing level winds

  1. #1
    Join Date
    Dec 2008
    Location
    I'm from Manhattan, live in Ct., but my heart is in SoCo.
    Posts
    120

    Default My own one bearing level winds

    I've been taking my own stock level winds from my 6500's and my Hubilie's, and have gently ground down the inner surface where the white plastic piece holds the end of the worm carriage. I did this carefully to not take too much off, with a fine stone, on a variable speed drill. I than fitted the line carriage housing with a 3x7x3 bearing. If you attempt this, do not force the bearing in place, it should slide in snug.
    And when using a vise, be careful not to damage the line carriage housing.
    Attached Thumbnails Attached Thumbnails 222 (600 x 451).jpg   222 04 again.jpg  

    EACH ONE, TEACH ONE !
    <*((())))>< <*((())))><

  2. #2
    Join Date
    Jul 2008
    Location
    NJ
    Posts
    12,822

    Default

    Nice work, Jimmy, always appreciate how you explain things so thoroughly.

  3. #3
    Join Date
    Dec 2008
    Location
    I'm from Manhattan, live in Ct., but my heart is in SoCo.
    Posts
    120

    Default

    Thank you, my friend.
    EACH ONE, TEACH ONE !
    <*((())))>< <*((())))><

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •